stroke < pixel pair > < stroke value > The stroke values modulate the power for each pair of pixels. Sets the stroke value associated with the pixel pair identified by <sample> to the value specified by <value>. The <sample> parameter specifies the pixel pair. The sample number ranges from 0 to one less than the number of pixels per stroke divided by the stroke increment. The number of pixels per stroke is determined by the mode NVS parameter "pixels_per_stroke" while the stroke increment is fixed at two (hard-wired by the LVD board). The <value> parameter specifies the stroke value. It is an integer ranging from 1 to 33. Adjusting this parameter from 33 to 1 decreases the optical output power of the corresponding pixels in the ON state. A value of 33 corresponds to maximum power. A value of 1 corresponds to maximum attenuation, i.e., it reduces the pixel power to 70 - 800f the maximum power. Adjusting this value has no effect on the power of the pixel group in the OFF state. The command "stroke cal" launches the automatic beam balancing algorithm which adjusts the stroke values for each pair of pixels. The stroke values are not calibrated in any real physical units. Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 This command is available. Field 27-Jun-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:25:40 2008 PST